Maintenance and maintenance of powder packaging machine
21-Jul-2022
With the development of society, powder packaging machines are becoming more and more extensive in the general field of the industry, but how much do you know about the maintenance and maintenance of powder packaging machines? Below we will analyze the specific maintenance and maintenance instructions of the powder packaging machine for you. The details are as follows:lubricating 1. Regularly add oil lubrication to the meshing parts of each gear, the oil injection hole of the bearing with a seat and each moving part, once per shift. 2. It is strictly forbidden to run the reducer without oil. After the first 300 hours of operation, clean the interior and replace with new oil, and then change the oil every 2500 hours of operation. 3. When adding lubricating oil, please be careful not to drip oil on the drive belt to prevent slippage and loss or premature aging and damage of the belt.Recommended lubricating oil Ambient temperature Lubricating oil -5℃~10℃ Industrial gear oil N150 (or ISO VG150) 10℃~40℃ Industrial gear oil N320 (or ISO VG320)
clean 1. The metering part should be cleaned in time after shutdown. For the packaged materials with high sugar content such as granules, it should be ensured that the turntable and the unloading door are cleaned every shift. 2. Clean the body of the heat sealer frequently to ensure that the sealing lines of the finished bag are clear. 3. For scattered materials, it should be cleaned up in time to keep the parts clean, so as to prolong the service life. 4. Clean the light-emitting head of the photoelectric switch (electric eye) frequently to ensure its reliable operation. 5. Clean the dust in the electric control box frequently to prevent electrical faults such as short circuit or poor contact. maintain 1. Regularly check the screws of all parts, and there must be no looseness. 2. Electrical parts should pay attention to waterproof, moisture-proof, anti-corrosion, anti-rat. Ensure that the inside of the electric control box and the terminals are clean to prevent electrical failures. 3. When shutting down, the two heat sealer bodies should be in the open position to prevent the packaging materials from being scalded.
英语
西班牙语
简体中文
