Home /
News /
How do you pack baby powder?
How do you pack baby powder?
11-Nov-2021
How to pack baby powder? Because it is a powdered product, it has higher requirements for the packaging environment. If the wrong method is used, danger may occur. In order to complete the packaging process safely, the following aspects can be considered.1. The choice of packaging machine for baby powderFor powdery materials, spiral weighing is generally used with high accuracy.Add a dust suction device to prevent the powder from spreading into the air.A safety shield is added to prevent the powder from flying into the air and also protect the safety of the operator.
2. Environmental requirements for packaging of baby powdera. Power guaranteeSome models use 380V three-phase power, and some models use 220V two-phase power. It is necessary to confirm the voltage according to the purchased model, and then connect the corresponding power supply to ensure the stability of the power supply.b. Environmental requirementsMainly the humidity and dust content of the air. Excessive air humidity will damage electronic components, and high dust content will affect the heat dissipation of the device. If it is flammable and explosive dust, if it is not protected when starting, it is easy to cause a dust explosion.c. Equipment lubricationEquipment maintenance personnel should regularly lubricate the gear meshing of the machine, the oil injection hole of the seated bearing and all moving parts. The reducer is strictly prohibited to run without oil. When adding lubricating oil, do not drop the oil on the rotating belt to prevent slipping and loss of rotation or premature aging and damage of the belt.d. Routine inspectionBefore use, check the screws of all parts, and there must be no looseness, otherwise it will affect the normal operation of the whole machine. Other electrical parts should be waterproof, moisture-proof, and anti-corrosion to ensure that the inside of the electric control box and the wiring terminals are clean to prevent electrical failures. After shutdown, the two heat sealers should be in the open position to prevent scalding the packaging materials.e. Clean regularlyAfter shutdown, the metering part should be cleaned in time, and the body of the heat sealer should be cleaned frequently to ensure that the sealing line of the packaged product is clear. The scattered materials should be cleaned up in time to better extend their service life. At the same time, it is necessary to frequently clean the dust in the electric control box to prevent electrical faults such as short circuit or poor contact.
https://www.china-packmachine.com/
英语
西班牙语
简体中文
